How To Nail Loose Hardie Board Siding

Placing your hardie board.

How to nail loose hardie board siding. Remove any nails that still might be underneath the bottom portion of the piece above the one you removed. If the hardiplank is being installed on a building in a humid climate or near the ocean or any large body of water the stainless steel nails are the first choice. Placing the new piece of hardie board is just as simple as the demo. 1 blind nailing measurements keep nails 3 8 in.

Hardie plank siding has a nail line across the top of the board that is 1 down from the top and nails are supposed to fall between and 1 from the top of the board to give the best hold. Any lower and you might see a few nail heads poking through the bottom of the next board any higher and your siding is likely to be loose and could even rattle in the wind. The original installer might have accidentally installed a nail too close to the edge of the siding causing a crack. From the top of the board.

Just the nails that will prevent the new board from sliding back into place you can either completely remove the nails or clip them off. Nails are driven through the sheathing into the studs. You can easily fix it by cleaning it and then using caulk to patch the gap. Inspect the hardieplank siding on the exterior of your home for loose boards which will leave your house open.

2 3 water resistive barrier finish nail blind nail 3 4 in 1 in. How to fix a loose hardiplank board step 1. Hardie board siding usually cracks due to poor installation. Nails for blind nailing should be between 1 in.

Slide a paint scraper against the surface of the loose boards in a back and forth motion while applying slight. If the fc lap siding boards are nailed very tightly you may be able to reach up under the board you are going to remove using a flat bar to pry gently at the top of the board beneath thus the board to be removed and the lower edge of the board course above it prying thus between the back of the lower board and the wall sheathing just enough to open the boards enough to go back to the hacksaw.