How To Put On A Metal Roof Yourself

Now that we have put the one inch clip on the metal panel and cut the ribs back flush we can install the panel by clipping it into the offset cleat.

How to put on a metal roof yourself. Take your first sheet of metal and place it on the roof so that it overhangs the edge at least 3 4 in 1 9 cm. Make sure that the panel is sitting back from the edge of the roof by half an inch. Install the roofing screws vertically along each rib in the panel. Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line.

Place the ridge cap over the roof. Be sure the larger edge is laid so that the small edge of the next panel will overlap it. Use your neoprene washer head screws to secure the metal to the sheathing. Apply butyl tape sealant in a thin line along the length of the foam closures.

In a standing seam roof long single panels run vertically all the way from the eave to the ridge. The ridge cap helps water to flow off of the roof. Place outside foam closures along the roof s ridge. Space the screws about 12 in 30 cm apart down the entire piece of metal.

Apply a thin line of butyl tape sealant along the roof s ridge.