How To Put Up Corragated Roofing

Use the rounded molding strips on the vertical rafters and the corrugated ones on the horizontal cross braces.

How to put up corragated roofing. Be sure before you fasten the roofing itself however that you lay down closure strips underneath where the screws will go. The corrugation should run up the roof toward the ridge. Insert about 20 nails into the humps of the ridges spread equally throughout the panel. Finish the first side of the roof.

Line up the first panel at the bottom corner of the roof near the lip and hammer it in place with 3 inch metal roofing nails. Screw the new panel in place as described. Buy the metal panels. Next pre drill holes on the end and side ridges of the panels spacing the holes 6 to 8 inches apart.

Ideally the wood beams will be located every 2 feet or 6 feet apart for steel beams. Use the corrugated molding strips on the horizontal cross braces and the rounded ones on the vertical rafters. You may need to cut panels to fit angles using a circular saw with a metal saw blade. Lay and secure the first metal panel.

For a secure and attractive finish you should use molding strips on top of the rafters. The process can be time consuming but with a nail gun it s significantly quicker. Continue this process until all the panels are safely affixed to the ceiling. Using galvanized nails attach the moldings.

Attach the moldings using galvanized nails to prevent rusting in case of any leaks. The silicone will spread and adhere creating a seal. Continue adding panels until the roof is covered. This will prevent leaks that lead to rusting.

Lay the roofing felt. 2 corrugated metal roof installation instructions. Beginning at the outside edge of your roof place each panel directly onto the purlins that are attached to the roof trusses. Install the panel so that the short lip overlaps the large lip.

The screws should be fastened at least 1 inch deep into the beams. To install corrugated roofing start by cutting your panels to length with an angle grinder. Drill the screws into the corrugated metal panels onto the beams every 12 inches. Complete the first row.

Drill a hole in the top corner on the valley of the corrugation not on the ridge.